Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello. I have some policy based NAT rules and static rules in place already that are functioning using some of my external IP addresses. Those NAT rules are used on the majority of my VPN tunnels to clients.However, I have a new requirement from a cl...
Thanks. I was able to find the Cisco doc that explained in detail that ordering of the NAT commands you posted. I will probably try it this weekend with the way mentioned because even when I make rule 50 a lower number like 4 and run clear xlate it s...
It is hitting the 5 policy NAT and translating out as that x.x.x.32 IP and not going through the VPN tunnel. I have tried putting the 50 policy in as a lower number than 5 and that did not make a difference even after clearing the xlate table.I'm at ...
