Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi! I have two ASA 5520 with AIP-SSM Module. I have configured stateful failover and I `ve got two questions. 1. When I power off the primary failover unit I loose contact with the firewall about 10 seconds,(I don`t think this is normal when you use ...
Hi!I have a problem to get the vpn-filter to work in my ASA5520 ver 7.4 and it`s urgent. The traffic don`tpasstrough, and i get this message in the log.(106023: Deny tcp src Outside:10.10.10.1/1024 dst Inside:192.0.0.20/23 by access-group "Outside_ac...
Hi!I have two ASA 5520 and i wonder if the following failover configuration is possible. Can i use the management 100 FE interface for sharing regular and stateful failover. If so we have 4 Gigabit interface to use for other tasks. Or do i have to us...
Hello!I wonder if there is a way to force the built in firewall in Cisco vpn-client to be active before a connection is made to a Cisco Pix 515 os ver 7.04. Cisco vpn-client version are 4.7./Regards Jonny
I have found the answer to the problem. You must have the sysopt command set to "sysopt connection permit-ipsec" NOT "no sysopt connection permit-ipsec" hope this will help somebody with the same problem. /Jonny
The inside net on the Pix are 192.168.1.0/24 and i have used ip adresses 192.168.1.210-230 for the vpn pool. And the inside net are using the outside interface ip adress when browsing internet. I don´t think i can do pat for the vpn pool because the ...
I can see the translation in log viewer (Built static translaton from inside: 192.168.117.100 to outside(test): 172.18.18.100) but the packet are not going in to the vpn tunnel any more, to destination 192.0.0.0. Here is the configuration Pix 501.acc...
