Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I've been working with a wireless network, where ap 1200 are being used as repeaters and ap1300 are being used as root.Sometimes, some of them get hanged, and must be reset.The software version of the ap's is 12.3(7)JA2.Here I attach a crash-info ...
Hi all,I've got a cisco Catalyst 4507R with a supervisor engine V. In this chassis, I've got a WS-X4506-GB-T card. This card contains 6 that can be SFP or 10/100/1000 RJ45V.When I connect a SFP with a fiber link, there is no link. I try to connect in...
Hi,All the ap's are using power over ethernet.Please, can you explain me about the downgrade you are talking about? Which is the purpose?.Thanks in advance.Regards.
Hi,Thanks for your answer about this issue.I've confirmed that all access points are running the latest firmware version (12.3.(7)JA2).I don't know what could be the cause of the problem.The ap are working with channels 1, 6, 11. So I think that the ...
Now, I don't have the two adsl lines to connect and make proves.But I have this message doing "sh ip cef internal" and "show ip nat stat":r1841_aud#show ip cef interIP CEF with switching (Table Version 6), flags=0x0 5 routes, 0 reresolve, 0 unresolv...
I have this configuration:interface FastEthernet0/0 ip address 10.10.1.1 255.255.0.0 no ip redirects no ip proxy-arp ip nat inside ip tcp adjust-mss 1452 no ip mroute-cache duplex auto speed auto!interface FastEthernet0/1 ip address 192.168.1.10 255....
