Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloI have a client which is having problems with his DHCP.There is a trunk configured with 2 subinterfaces, both with encapsulation and 2 ip helper addresses.The client sees only 1 DHCP pool working.Is there a known problem on this kind of router?I...
Hello everybodyIs there somebody who knows how much VRF's I can configure on a 2851?If possible, also let me know where I can find this info myself.Thanks in advance
HelloTomorrow I have to configure HSRP between two Cisco routers and a non-Cisco firewall.The first router provides WAN connectivity, the second is for back-up reasons.The firewall Trusted port is for the customer LAN and the Untrusted I can connect ...
HelloCould somebody help me?In this network: PC>>C2900XL>>R1721>>R2523I can't ping the R2323 router from the PC.This is my PC config(no firewall):172.16.1.18255.255.255.240172.16.1.1In attach you can find the configs from both routers and the switch....
HelloI tried to put an other IOS on a 1721 but failed in doing this.Flash was erased before putting the new IOS on it but I keep getting the message that there is insufficient memory.In rommon I see:rommon 1 > dir flash: File size C...
Hi ToshiI see no hits on the deny statements in acl 111.A few days ago I allready added a extra acl for udp packets.But the customer hasn't been on-site since then and thus the network is still configured with static addresses.So it is not yet possib...
Hi RickIndeed, it is vlan 1000 which is not working.But after a few tests and changing the configs I forgot to put back acl 111 on the first subinterface.ACL 111 is now configured on the first interface as well and this still works.Normally it is con...
HelloYour down/ upstream speed is 2464/768.I can see some Header, Reed-Solomon EC and CRC Errors, EC =Corrected errors. Noise margins lower than 10dB are not good.An other thing you have to look at is the used capacity, if this is higher than 80% yo...
