Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a WLC9800 L. I installed a wildcard cert and set a trust point. Now I cannot access the management via GUI. I can still access via putty using the IP. I followed the Cisco documentation for installing the cert but Haven't found anything on t...
I have a new 9800 L configured on the network. The corporate WLAN is working and we are getting DHCP. However, on our Guest WLAN I cannot get DHCP to work. For the Guest WLAN we have vlanxxx with DHCP coming from our firepower on a DMZ interface. ...
I removed the trust points and the key pairs and brought the certificate in again. I didn't change the trust point under HTTP/HTTPS/Netconf and I can access via the GUI. Then I went into Web Auth - Global and changed the trust point. Now on my guest ...
Its a wildcard certificate we use for many things in our network. If I go back to the self-signed cert I can get back into the gui. If I ping the controller by name it returns the correct Domain Name. The trustpoint hasLabel - the name of the certif...
