Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day,If I have two Cisco 5508 Controllers, running Software version 7.4, how would my failover happen when the AP's run in local mode, and the local controller fail, and you configured your remote controller as your secondary controller. Questio...
Good day,We have purchased a few WAP4410N access points at some of our small remote offices. The switches in the offices is not PoE capable, therefore we require power injectors. I have a PWRINJ3 injector in my posession, so have tested it with the...
Hi Sweigle88.Have you had any luck on this? I'm trying to deploy the FTDs and instantly register with FMC without having to log into the FTD initially. Can only find autoscale templates which is not how I want to deploy.
Thanks Waseem, so I have the limitation of 25 APs per FlexConnect Group at the site then. If I have more than 25, I'll have to configure two or more Flex groups, depending on areas where the clients will roam. Can you configure one SSID on the cont...
