Hello ,  am using nexus 3k with VPC pair. I need your recommendations , if I configure vpc 100 for server with trunk interfaces. what should be the spanning-tree port type will be used if i have following cases. the sample configuration is mentioned ...

Hello All,  am trying to use 40G QSFP as peer link between two Nexus 3000, i can see transceiver but interfaces are getting up  as mentioned below:- Nexus3k # show interface ethernet 1/49 transceiver  Ethernet1/49     transceiver is present     type ...

Hi,  Am trying to NAT from OUTSIDE to Inside (with redline), but unfortunetely not working properly.  At same time from Inside to Outside(with Greenline) it is working fine. Configuration is mentioned below and thank for your assistance.  ISP01#show...

Hello All,  am trying to configure NAT outside to access host behind natting device, but am not able to access it. The config snapshot is mentioned are mentioned below for your support. Thanks in advance for your tips. I have configured DNAT but it b...

Hi Team,  am using 2x9300 catalyst switches and i have configure two interface from server with two different VLAN 148, 14 and between two switches I have port Chanel with trunk . am getting this error on both switches , thanks in advance for your as...