Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are receiving numerous CRC errors on the Radio interface for a Cisco 1310. It is a point-to-point bridge connection; both Root and Non-root are generating the errors.Description (Lifetime-Last 5 seconds)Header CRC Errors 15088213-125Protocol Defer...
Hello everyone. I have been searching for documentation from Cisco regarding a secure configuration for Cisco 1300 series bridges. I have viewed the "Cisco IOS Software Configuration Guide for Cisco Aironet 1300 Series Outdoor Access Point/Bridge" (h...
Hello everyone.Is it possible to run two antennas from a 1300? We have three sites that we need to connect (one root node, point-to-multipoint). All 1300s would run in bridge mode. We are curious if the root node would need two antennas to receive si...
Good afternoon everyone.We are trying to pass traffic from a Cisco 831 to a Pix 515 over broadband. Both have static ips. When trying to establish the tunnel (sending a ping), we can see that the tunnel shows a status of "UP-IDLE" from the 831 and th...
Hello everyone.We recently installed a Cisco 831 at a remote site and are wanting to connect it to our WAN. We currently have two PIX 515e (failover mode) with remote sites connecting to us via IPSEC vpns and clients authenticating through W2KR...
The original issue has been resolved. It was a routing issue in that the LANs subnet masks collided. By changing the 831 IP schema traffic was able to be passed from the 831 side to the PIX Lan (IPSEC VPN tunnel made).I am still troubleshooting estab...
Unfortunately, this did not correct the problem. The tunnels still how a state of "QM_IDLE" and when viewing the "show crypto ipsec sa" on the 831 (the sending side) it shows numerous sending errors. I have checked the policies on both sides but sti...
