About perapapak

perapapak · 07-08-2009

Hi,We have following situation. Asterisk as PBX and 2 SPA942 and 1 PAP2 with 2 analog phones connected. All is working prefectly until we added WRP400 to replace PAP2. Analog phones connected to WRP400 are registered on Asterisk. They are ringing on ...

perapapak · 11-12-2009

Hi,I just tired but it seems WRP400 don't accept this configuration or I did something wrong. See attached files.I use WRP as WLAN and 3G access point ans ATA. One device instead two (wlan access point + PAP2).Regards,Pera

perapapak · 11-12-2009

> 2. Configured WAN interface of WRP400> [it's a router, if this interface is not properly configured, the voice lines will not properly register with the Asterisk > server] What you mean e...

perapapak · 10-27-2009

1. factory reset of WRP4002. Line 1 only user credentials and proxy.3. Attached analog phone on line 1 of WRP400Trying to call another extensions form phone on line 1. I hear after dialing only busy tone. No activity in Asterisk log.Trying from anoth...

perapapak · 10-23-2009

> Looking at your config, I see that you have changed the SIP and RTP ports. A typical problem when RTP is restricted, in any way, is one- > way audio.I have NO AUDIO and not one-way audio. The ports are the same such in PAP2 and RTP ports from Aster...

perapapak · 10-02-2009

Hi Patrick,Here is it.FYI: echo test with Asterisk and phones connected to the WRP400 failed. No audio. The phones connected to the PAP-2 working fine.Regards,Papak

Member Since	‎07-08-2009 07:05 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	17

User Statistics

User Activity

WRP400 Voice no audio

Re: WRP400 Voice no audio

Re: WRP400 Voice no audio

Re: WRP400 Voice no audio

Re: WRP400 Voice no audio

Re: WRP400 Voice no audio