About lh

lh · 10-01-2005

I upgraded my 2610 routers to c2600-d-mz.122-29.bin - Now I have the commands to make dot1q trunk on the ethernet port (10Mb) I connect with a switch with more VLAN's defined. The trunk line is up (sh interface trunk) But I'm not able of getting conn...

lh · 02-23-2006

Hi our thereI have had this problem with RIP and defaul-information originateI tried the no-autosummary - and it didn't work :(Though, I found a way to get it work :)It seems that typing the command "default-information originate" does not put the 0....

lh · 10-01-2005

But I got it working on the c2600-d-mz.122-29.bin image. On a 2621 router. And it works fine.Only on the 2610 I can't get it working :(

lh · 10-01-2005

You seems to be right. It must be some limitaiton of the 2610 eth hardware.Even though cisco states that it should be working with 2610 and 10BaseThttp://www.cisco.com/en/US/products/hw/routers/ps259/prod_bulletin09186a00800921e4.htmlbut thanks anywa...

lh · 10-01-2005

I tried to find the IOS, in the download area, but no ipbase ver 12.3 :(I found this document: http://www.cisco.com/en/US/products/hw/routers/ps259/prod_bulletin09186a00800921e4.htmlIt say that from 12.2(2)T it should function with the 10BaseT built-...

lh · 10-01-2005

I can type all the commands to setup the dot1q functions. everything seems to bee ok.and seen from the switch the trunk is up and ok.But no inter-VLAN routing.I use the same IOS on the 2621.According to the following document it should function.http:...

Member Since	‎10-01-2005 05:03 AM
Date Last Visited	‎10-09-2017 12:20 PM
Posts	6

User Statistics

User Activity

Inter-VLAN on 2610 router - IOS:c2600-d-mz.122-29.bin

Re: RIP2 and Default Gateways

Re: Inter-VLAN on 2610 router - IOS:c2600-d-mz.122-29.bin

Re: Inter-VLAN on 2610 router - IOS:c2600-d-mz.122-29.bin

Re: Inter-VLAN on 2610 router - IOS:c2600-d-mz.122-29.bin

Re: Inter-VLAN on 2610 router - IOS:c2600-d-mz.122-29.bin