Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a client that no documentation of the PIX they have and the have 4 Tunnels setup. They are moving and are getting new IP's. I remember to view the isakmp keys was to do a wr net to a tftp server and it shows the passwords. I have done this b...
One of my Clients have a couple of Site to Site Tunnels and now they would like to setup a VPN Client as well. I noticed on the Config that the Client is setup however using RADIUS authentication which to my knowledge is being used. I take out the ...
I have inherited a Cisco PIX 515R I was working on and I cannot load a image onto the PIX at all. I know all the little tricks and what you are suppose to do but it still doesn't take an image. The only thing I can get it to do..if I load ver 5.0.1...
I got an additional IP Range from my ISP how can apply that to my PIX so I can use that range as well as my current range. I have a PIX 515 6.3.5 Thanks in advance
How can I add a Remote Access VPN Connection on a PIX for a user to access their network from home when the PIX already has a VPN to VPN Tunnel to another Network.
VLAN1 option is going to work for them. They have too much going on for that to happen.Basically what could I use CLI wise to add the new IP Range so they can use it when needed? Could you give me an example config.
