Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am stuck trying to figure out how I can link my 3 topologies together without changing it too much and breaking the connections.Such that my Main topology's PCs can still ping each other successfully.Such that my Multilayer topology's ISP and PCs c...
I am not sure why it isn't working. It is meant to work after I enter access-group in_to_internet in interface outside and then on PC6 it will go Reply from 8.8.8.8: bytes=32 time=0ms TTL=126. My .PKA file is below please have a look.Here is the top...
I have a topology of PCs A, B, D, and E, 2 routers R1 and R2, and 4 switches A, B, D, and E for each of my PCs respectively.
PC A IP is 201.4.100.1/28 with a default gateway of 201.4.100.2,PC-B IP is 201.4.100.17/29 with a default gateway of 201.4....
Yes I would have used an OSPF for this assignment (on my main topology) but my teacher wants me to use IP route for it so i have no choice but to. I did OSPF on my ASA topology (the ASA and Multilayer switching topology are the only ones I can edit i...
Hello,I am unable to touch R1, R2(I have to use 2901 routers) and the PCs and switches A, B, D, and E as it is the topology my teacher requires me to set up. I also can't change the addresses of my main topology as this is an assignment to put my und...
