Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When I use two tacacs-server, the tacacs dosn't take the secondary tacacs-server. When one of the tacscs servers are down, the router takes always the first.Image:c3640-ik9s-mz.124-5a.binConfig:aaa new-modelaaa authentication login default group taca...
Hy,one of my 3550 catalyst switch Port get always the message "LOOP_BACK_DETECTED: Keepalive packet loop-back detected on GigabitEthernet0/11". This Port goes then in the err-disable state. When I take the syntax "no errdisable detect cause loopback"...
Who can answer me,what this syntax"switchport allow vlan 1 untagged (tagged)" with in purchase of native vlan means. Then, when I configure this syntax, how to configure my uplink on an access Port?
Hy,thank you for answering!To the first question, that is correctly.To the second question, when I use the second taccacs server as the first in the router config it functionally.To the third statement, when I make a tacacs debug on the router, the r...
