About eddyfonseca

eddyfonseca · 01-04-2023

Hello Allbug issue CSCvn98813I have the same issue once I provision the switch and it shows up on the 1st floor I am not able to move it to another floor / location. It show no hyper link and is shaded gray. I am on Version 2.3.3.6-70045 so I did n...

eddyfonseca · 01-12-2023

If I discover a switch how does it get into the fabric, I have not done anything else with the switch other than discover it and place it on a site>building>floor. when you speak about a fabric what are you referring to so I can get a better under...

eddyfonseca · 01-04-2023

I have the same issue but it seem the move option is selective to the switch or object. I am able to move with the same hardware but on another floor it does not allow me and is gray out. I do not want to remove the hardware from inventory but I do...

eddyfonseca · 12-30-2022

I am not able to access this URL. If you have another link or a PDF that will help. thank you

eddyfonseca · 12-30-2022

This information was helpful. I was able to discover the device and it should have created the cert on the WLC and just allowed me to harvest all connected / Anchored AP on this controller. I think this should all be automated. I will go thru the...

eddyfonseca · 12-28-2022

Hello AllI have a 9300 controller but it does not update DNA with the new AP we have added. I would like to know also why the AP that were discovered do not show any client but when I look at inventory I have them place in a building/ floor/ but it...

Member Since	‎12-28-2022 10:34 AM
Date Last Visited	‎02-22-2023 12:01 AM
Posts	6
Total Helpful Votes Received	1

User Statistics

User Activity

Device site re-assignment not possible after provisioning

Re: Move / Relocate device

Re: Move / Relocate device

Re: How to manually connect a Cisco WLC to Cisco DNA Center for Networ

Re: How to manually connect a Cisco WLC to Cisco DNA Center for Networ

Re: How to manually connect a Cisco WLC to Cisco DNA Center for Networ