I need to service Isolated VLANS and I don't want to use VM's or setup a DHCP server for each VLAN. Since I need more than 256 IP's on many VLANS, I'm trying to figure out what to do. I do have 9400 switches connected to the FTD's but I'm wavering ...
I've configured DHCP relay on the FTD and I have a 2nd FTD as a backup default gateway. x.x.x.1 and x.x.x.2 respectively. However something is wrong. When I enabled DHCP relay on the .1 FTD only, the DHCP relay wouldn't work and then I enabled thi...
This is a site-to-site IPSEC tunnel. Everything looks good, including the packet capture but the packets aren't seen on the far end on their packet capture (the other company on the other side of the tunnel). Both sides are using Cisco FTD's. How ...
We have a customer who uses a basic VPN service and it doesn't support NAT-T. Been trying for days to get it to work but it won't work. We contacted the Vendor and they stated that they don't support NAT-T IPSEC tunnels. IS there a way to deploy a...
We need our users to have a Whitelisted IP address to access certain content. However, even when I choose "Allow all traffic over tunnel", I still can't get the Hairpinning to work. How can I make this work?
This is an IPSEC tunnel between us and a partner. I want to setup the IPSEC with as much redundancy as possible. We are trying to achieve 5 9's but can settle with 4 9's but uptime is essential because we have production tied to the connectivity to ...
You can connect a console cable to the console port through a usb port on your computer but the easier way would be to connect through to the web interface. We would need to have a model # to help with more specific answers.
