Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi all
I aim to configure the router in GNS3 two ipsec
Connections is everything, but I do not know why the ipsec transform-set mode change when I am nothing happens!
I expect by changing the connection mode, but the embryo does not happen and also n...
hi all
I aim to configure the router in GNS3 two ipsec
Connections is everything, but I do not know why the ipsec transform-set mode change when I am nothing happens!
I expect by changing the connection mode, but the embryo does not happen and also n...
hello my friendsHow Cisco detects RTP packages?RTP pachet What is header that can detect?RTP Are UDP alone !Even in Wireshark not detected !!! only UDP view in wireshark
I found the correct answer ...Rtp packets of bits are identified and NOT be determine the port numbers UDP !if first bit number 8 (1 0 0 0) , then packet = RTP !you can generate packet and see by software HEX editor Good luck friends ....
