I have this scenario mpls vplsCE1---PE1----P0--P0---PE2---CE2between PE1 and CE1 3 interfaces 10G between PE2 and CE2 3 interfaces 10GPE1 configVSI Configvsi L2VPN staticpwsignal Idpvsi-id 22peer 10.10.10.2interface GigabitEthernet8/0/1012 binding vs...

I need to configure my router to do natting using WAN port, it natting but only from LAN interface but from host in my lan with ip 192.168.1.2 not natting even NVI0 is not enabled why????????Router#shRouter#show runRouter#show running-configBuilding ...

I have router 7604 and when i apply police-map to interface port-channelto limit the rate but when i see the monitor the port didn't drop the packet when reach the maximum ??port-channel with 4 interfaces Gigpolicy map with 2.8 Gig

Hello everybodyif i have big network and i run isis as routing protocol and i need to automatic load balance if the link reach 50% of the maximum capacity how can i do ti ? IP SLA ?Thanks,,,,

i have this topology  and i need to connect the tow 3725 over mpls xconncet , vc is up but there is no ping between  tow 3725 vc is up . Current configuration : 1812 bytes!! Last configuration change at 08:17:28 UTC Mon Jul 31 2023!version 16.6servic...