Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have erased the startup config,reload the switch and then applied the new config script including the "enable secret xxxx" I exited the switch and when i try to log into the console subsequently i get the first level access but donot getinto previl...
We have a setup as follows: There is a 3rd party VPN box which is connected to internet and we have firewall(PIX515E) doing NAT and connecting to a LAN behind.The users on this LAN use 3rd party VPN client to connect to the VPN server on the other si...
we have implemented a remote access network for our customer using AS5300s and cisco 3600 series routers with appropriate modem modules at different locations in the customer network. The current network has TACACS authentication.We have to implement...
HI,I just got a brand new 7300 router and powered it and it asked to upgrade the FPGA and i clicked yes.subsequently it started programming successfully but the end result is that the 7300-CC-PA card (atm enhanced E3 line card is not recognized and t...
HI,I just got a brand new 7300 router and powered it and it asked to upgrade the FPGA and i clicked yes.subsequently it started programming successfully but the end result is that the 7300-CC-PA card (atm enhanced E3 line card is not recognized and t...
Thankyou for the suggestion. I had already done as per the password recvery procedure excepting the last couple of steps whisch is from point No. 9 onwards.I did another interesting thing to get the config.Maybe others could benifit from my stupid mi...
I triedputting into a diffnt slot as well but still I get the following error"00:00:19: %LC-2-LCSYNC: Line Card type 963 in slot 3 serial link sync failed.00:00:19: %LC-3-DEACTIVATED: line card in slot [3] deactivated.-Traceback= 4049FA2C 401B3720 40...
what is the meaning of "Line card is Wedged". I already tried powering off the box and powering ON after re seating the card in the slot..no improvementI should open a tac case i guess..Thanks for the quick support
Pls. find the sh ver and sh diag 2 outputregardsMurtyRouter#sh verCisco Internetwork Operating System SoftwareIOS (tm) 7300 Software (C7300-JS-M), Version 12.2(11)YZ1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)TAC Support: http://www.cisco.com/tacCopyri...
