Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!
Im trying to connect MDS 9148 to existing fabric. I have an issue with one of vsan (31). All other vsan work fine. Ports for vsan 31 are in Isolated state. I see a reason of this behavior: Isolation due to domain not allowed. But I don't under...
Hi,We are using CUCM 7.1 with Cisco 2901 15.2.1T as a CUBE. There is SIP trunk between CUCM and 2901, and another SIP trunk between 2901 and SIP provider. When we want to hold/transfer external call, which is coming from SIP provider, it is terminate...
Hi!I have a problem with B-ACD on CCMe. B-ACD has two options: transfer to hunt group and dial by extension. If I call to B-ACD from internal IP phone everything works fine (both options). If call comes from SIP provider I can chose any option, but...
Hi!How can I check file names of IOS and asdm loaded to FWSM? If I load new version of IOS, how can I erase the old one? Is it rewrited automaticly?Command "dir flash" shows only that they presented on the flash.dir flash:Directory of flash:/2 -...
Hi!I need to gain access to admin context which is located on FWSM module. I don't know it IP-addresses, because other man performed configuration before me. The command "session slot" didn't help me:session slot 3 processor 1The default escape chara...
Hi,Call flow is correct.We are using IP phones 7911. As I know this phones don't support G722.Also the same problem is appear with HOLD. So may be problem isn't in G722?Can I centrally disable G722 on CUCM?
I don't see call again too . I think that I am doing something wrong.Id 2189 presented only on GW. This is pilot number. CUCM doesn't know anything about it.
