Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey experts,
I have a pair of remote Leaf(s) of N9K-C93240YC-FX2 connected to the Fortigate firewall as an IPN device.
Based on the IPN requirements, it is possible to connect 1G or 10G SFP from the leaf to the IPN device.Now, since this leaf has 48p...
Hey all,
I have an MX-9000 where vCenter is installed. I need to integrate vCenter with ACI --> VMM Integration.
I understand the idea of VMM integration, where any EPG integrated to VMM, a virtual portgroup, is pushed by ACI to vCenter, so no action...
Hey All,
I have a AIR-CT2504-K9 WLC [version = 8.5.105.0] with 17 APs mix from these AP Models:
AIR-AP2802I-E-K9
AIR-CAP1532E-I-K9
AIR-CAP1832E-I-K9
AIR-AP2702I-E-K9
I got this error: "DTLS-3-HANDSHAKE_FAILURE: openssl_dtls.c:844 Failed to complete ...
Hey Folks,
I'm upgrading my ACI fabric within two stages from:
5.2(3) to 5.2(8i)From 5.2(8i) to 6.0(7e)(M)
Based on Cisco recommendation, any Cisco App Center should be disabled prior to the upgrade process. I found my customer has the "Nexus Insight...
Hey Folks,
I have an APIC cluster consists of 1 hardware APIC and 2 other Virtual APICs.
I was looking for a command that shows if my two virtual APICs were installed as Vapic or as AVE (Cisco ACI Virtual Edge).
I found the command `show fabric nodes...
I had a similar issue where the Nexus sw was running an ACI image. After `touch clean`, the SW was stuck in the loader prompt.
The only solution that worked with me is1. Copy an NXOS to a USB.2. Boot the NXOS image from the USB.3. During step 2, the ...
I tried the command you mentioned yesterday at the first time the error came up and the AP reach the WLC successfully. today the same issue occurred again!
what I did is that I checked the connection to SSE by running the command: `curl -v -k https://api-sse.cisco.com` and I noticed that this domain is not reachable. So my customer didn't need access to SSE before the upgrade and doesn't need it now !!
...
