Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a configuration with a PIX 515 running 6.3 code and I can establish a tunnel connection but run into the same problem of not being able to ping any device on internal LAN. I have been over this configuration quite a few time is there something...
All that time studying CSVPN an I forgot about that. I applied and ACL to the internal interface allowing traffic from the IP Pool to the inside network and I was able to ping all of the devices, in addition after moving my connection behind the fire...
Pings initiated from either side are encrypted however that decryption never occurs with the associated peer. So I think you are very correct with the route to the IP pool. I attempted to apply a default route first to inside interface w/no success a...
