Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,Normally when I upgrade the IOS image of my Cisco Router, I boot it in ROMMON mode, and then do the upgrade activity.I have a special requirement for which, I have to remotely upgrade the IOS without console access to a Cisco box. Flash capct...
Guys,I am planning to upgrade IOS of my routers. I need to find whether existing flash and DRAM is enough for the new IOS version. I have following routers in my network:1700, 2600, 2800, 3700Can someone please tell me how to interpret the output of ...
Hi Everyone,I have a router, on which I have enabled SNMP traps. These traps are sent to my HP OV NNM server. I have a PRI interface on this router, which is serial 0/3/0.I want to receive link down traps only from serial 0/3/0:23, which is the signa...
Hi All,I am tryiung to monitor my VPN Concentrator 3030 using HP OV NNM. I have done following configuratrion on my VPN Concentrator for this.Configuration | System | Management Protocols | SNMP Enable Port 161 Simultaneous Connections 4Configuration...
Hi Paresh,Thanks for the response. I have referred to Cisco site, and it says that the calculation is not same for all router models. For some router models, what you have mentioned is correct, but for some router models, it is only the first figure,...
Hi,Thanks for your reply.I get the same error message ever if I try with version 1. Here is the output of the same# snmpwalk -v 1 -c snmpwalk: SNMPv2: Commit failed.
