I currently have a Cisco 2600, IOS v12.2(5d) with one WIC-1DSU-T1 interface card. I'd like to upgrade (or add, depending on what the carriers says) this circuit to a T3. What interface card would I need to add? Thanks in advance for any help.

Brand new 1841 router. Connected to the console and ran through the initial setup, changing the enable secret and enable passwords. After setup I did a conf term and entered the following - no username cisco, then wrote the config to memory. The r...

Will a PIX 506 v6.1 support redirection of port 443 to an internal web server? I notice there is no fixup protocol https 443 command. The intent here is to allow only HTTPS traffic to the web interface of an Exchange Server. Many thanks in advance...