Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a internal node in the environment and our IPS is catching in the event logs stating it is sending traffic to victim ip 0.0.0.0. I am assuming that 0.0.0.0 means a broadcast, is this correct?
hi, from asdm or cli you can try packet tracer to see if the acl is blocking it. have you added the client vpn source range SA thru the s2s tunnels? hth!csm
hi, that is bummer! it seems the master cannot communicate to the secondary switch now. it looks like the switchfabric is stuck in the 1st few phases of election process. how is your switch stack cabled at this time ? can post the running configs o...
try config t int gi0/0/0mtu ? -i know from switching side some of the newer blades we ordered on the 6509s didnt allow the jumbo mtu option, we have to use our old blades to set mtu higher than 1500, i am not sure on the ASRs HTH
