Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
That's fine. If you subnet your /24, you'll need to advertise a /24 aggregate address out to the Internet. Use the summary only parameter in the aggregate command.http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080094826.shtml
The ISP's router, which is your ASA's default gateway, will need a static route pointing the /27 out the interface that faces the ASA's outside interface. Your ASA needs to have static NAT entries using the newly assigned /27. When the ISP's router r...
Hi Jack,You would use the input keyword to configure the actual input queues on switches that support them. I can't remember the hardware platforms, but on newer switches and bigger platforms, there are two input queues that could buffer frames in ca...
Hi Jack,to map CoS 1 to Queue 1 and CoS 3 to Queue 2, enter:mls qos srr-queue output cos-map 1 1mls qos srr-queue output cos-map 2 3And then verify with show mls qos map cos-output-qTo drop CoS 1 traffic in Queue 1 when output queue level hits 60%, e...
