Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,I am trying to configure RSPAN between two 2950 SI switches (I did not see any reference that SI does not support RSPAN source/destination, so I suppose it should work)source: SW1 \ PC1 (connected on SW1's Fa0/24, access port in VLAN1)destin...
I have completely lost the config on one of my switches, however I saved the config a couple of days ago via CNA. I have to extract the saved backup file from my hard drive, so I can copy this to the switch via TFTP. I cannot use CNA to restore the c...
Hi all,I upgraded 2 of my 2950 in my LAN to the most recent IOS 12.1(22)EA14 and enabled SSH (they were EA13 before, and using only telnet). After these changes, I can no longer see the trunk link between these 2 switches if I open my CNA community. ...
Hi all,I had a very disappointed experience today during the planned upgrade on my 2960 to IOS version 12.2(58)SE2 after business hours. We have a small office with 3x 2960 and a couple of 2950. There is a single 2960 called as the "central" as its ...
Hi,I just upgraded the IOS in my 2960's to 12.2(55)SE due to the new SVI static route feature. However, I noticed a serious issue on some of my 2960's:-the boot failed on one of them, and stopped at the "boot:" prompt. I had to re-issue the boot comm...
Even if nobody replied with anything useful, I wanted to give another headsup to this issue (hoping someone provides feedback): since 2 days, it started to log this error message every 10 seconds. The switch is still running thoug, so I am not sure i...
Hmm, I think I wait a couple of months till I do my upgrade, cause this madness freaks me out and dont want to play on the prod network with beta releases accidentaly marked as gold
2950 (being either Standard Image or Enhanced IMage) both support rapid-pvst. Upgrade to the latest version 12.1.22 EA14, and you will have this feature. I dont see any logical reason sticking with a prehistoric software version, except to make your ...
