Buy or Renew
Buy or Renew
pasztor.richard
Level 1
Level 1
Member since ‎09-26-2010
‎08-18-2017
Recent Badges
Awards

User Statistics

  • 35 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
See all
5 Discussion Posts
30 Discussion Posts
20 Discussion Posts
First Discussion
10 Discussion Posts

User Activity

RSPAN on 2950 SI

10-15-2011
Dear all,I am trying to configure RSPAN between two 2950 SI switches (I did not see any reference that SI does not support RSPAN source/destination, so I suppose it should work)source: SW1 \ PC1 (connected on SW1's Fa0/24, access port in VLAN1)destin...

Where does CNA store the switch backed up configs?

09-15-2011
I have completely lost the config on one of my switches, however I saved the config a couple of days ago via CNA. I have to extract the saved backup file from my hard drive, so I can copy this to the switch via TFTP. I cannot use CNA to restore the c...

CNA does not show trunk link between 2 switches

09-11-2011
Hi all,I upgraded 2 of my 2950 in my LAN to the most recent IOS 12.1(22)EA14 and enabled SSH (they were EA13 before, and using only telnet). After these changes, I can no longer see the trunk link between these 2 switches if I open my CNA community. ...

12.2(58)SE2 on a 2960 cause memory leaks

09-07-2011
Hi all,I had a very disappointed experience today  during the planned upgrade on my 2960 to IOS version 12.2(58)SE2 after business hours. We have a small office with 3x 2960 and a couple of 2950. There is a single 2960 called as the "central" as its ...

2960 IOS 12.2(55)SE heap fragmentation

09-26-2010
Hi,I just upgraded the IOS in my 2960's to 12.2(55)SE due to the new SVI static route feature. However, I noticed a serious issue on some of my 2960's:-the boot failed on one of them, and stopped at the "boot:" prompt. I had to re-issue the boot comm...
Community Statistics
Member Since ‎09-26-2010 12:31 AM
Date Last Visited ‎08-18-2017 03:54 AM
Posts 35