Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an extensive network that I care for on-site and I have run into a problem that is baffling me. We have a single layer 3 switch that handles inter-VLAN routing with several large layer 2 switches that are used as distribution switches for the...
Thank you for your patience, I chose to use the command "ip route 0.0.0.0 0.0.0.0 10.251.9.1" as this is what the other distribution switches were configured with and as per your instructions the "show running-config | section ip routing" was blank.I...
1. Yes, I can ping from the L3 switch SVI to the problem switch, see below.Spoiler200-CSW-9161#ping 10.251.9.6 source 10.251.9.1Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 10.251.9.6, timeout is 2 seconds:Packet sent with a source...
