Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a clean install of VMWare 6 on two Cisco UCS C220 M3 units. I've installed a redundant Nexus 1000V installation with a VSM and VEM on each host. It is an L3 deployment. Below is a 'show module' taken before the problem occurred.
n1kv# sh mo...
I have just installed ACS 4.2 on two VMware hosts. I've configured database replication but it won't work. The error message is "shared secret mismatch". This error message occurs if a NAT device is in the path (which it isn't in this case) or if ...
I found the problem. I had my vmkernel NICs and my VSM NICs in the same port-profile. The 'capability l3control' command is for use with vmkernel NICs. I created another port-profile for the VSM NICs and migrated them to it. The system is now abl...
Hello Nick. Sorry for the slow reply I've been out of the office. I followed these instructions:http://www.cisco.com/en/US/partner/products/hw/vpndevc/ps2030/products_configuration_example09186a0080742f60.shtmlThe instructions tell you to create an...