Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I got a problem with a Cisco 1841. This router has 2 modules with 4 analog modems. The modems are connected to the telephone line wich are working fine.To this router I connect in case of a backup with 4 external analog modems connected to a c...
HI all,does someone has a guide to activate WPA on the WLAN on a cisco 876W ?I?ve tried it and I see the network but I can?t connect.I would like to connect with a windows XP SP2 with WPA and TKIPThanks a lotKai
Hi all,I got a question concerning the IOS installed on my Cisco 876W.I got a Cisco 876W with ADSL, WLAN and ISDN S/T Inteface and a LAN 4 Port Switch.I want to use the ISDN as a Backup connection if the ADSL fails.I?ve read the config guide and ther...
Hi all,I got a hopefully easy to solve problem.I got a PIX 501 which is directly connected to an ADSL Modem.It gets the IP from the provider and I am able to ping official ip addresses in the internet.THe pix should build a vpn tunnel to a cisco 3005...
Hello all,I?ve configured a Cisco 836W through the GUI. The problem is that the router does not dial out and establish the VPN Connection.Attached the config filethanks for your helpKai
Hello,I got a new router and there the ISDN BRI is OK. I got a reply from debug ISDN q921.When I make a debug q931 I got the fowllowing:*Mar 1 08:13:41.535: ISDN BR0 **ERROR**: process_bri_call: Outgoing call id 0x8050 blocked*Mar 1 08:13:41.535: I...
Hi all,I?ve checked the router several times and asked around but it does not dial.curious: when I make a debug isdn all no message is deplayed.(for information: term mon is enabled)the frontpanel led of the router shoews me that the link to the isdn...
Thanks for the filebut it does not work.attached the current config.I do not what to do anymore....I?ve configured other routers with ISDN and they work well....only this router will not dial.....RegardsKai
Hi,yes I know it should give an output but it does not.I added the nat outside on both ATM and BRI interfaces but no action.So I will describe you the situation and I attached alo a pdf which shows the physical situation.The router should be connecte...
