Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have created a VPN tunnel between sitea and siteb. But unable to ping inside interfaces for both sites.Could you please suggest what to do. When i look up the PDM page on both Sites PIX 501 its Showing.=========================================VPN...
HiI have linksys wireless modem/router my network currently working fine on this device. I bought Cisco pix501. i have configured the PIX. ip address outside pppoe setroutevpdn group Internet request dialout pppoevpdn group Internet localname xxxxxx@...
HiI have linksys wireless modem/router my network currently working fine on this device. I bought Cisco pix501. i have configured the PIX. ip address outside pppoe setroutevpdn group Internet request dialout pppoevpdn group Internet localname xxxxxx@...
HiI have linksys wireless modem/router my network currently working fine on this device. I bought Cisco pix501. i have configured the PIX. ip address outside pppoe setroutevpdn group Internet request dialout pppoevpdn group Internet localname xxxxxx@...
HiI am trying to create vpn tunnel between two pix 520. Please see my attched config. If any commands missing or error in commands please guide me. Please note i am new to pix firewall. i have configure both pix by referring notes.Thanks
Thanks for reply. I have tried still same problem. One thing i forget to tell. I can ping from command prompt to remote PCS, but i am unable to ping 192.168.0.1 and 192.168.1.0 remotely.When i try to ping from the PDM -Tools-PING unable to ping any r...
Thanks for replying I have entered the command "logging on" in the pix. How do i capture "deb cry isakmp" and "deb cry ipsec"?Please check my first attached post for PIX configuration.The source and destination IP Addresses are matching the access-li...
