Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We'v enabled CDR and Call Diagnostic in CUCM CallManager Service paramters. However, when we run the CMR export the call quality stats are not being recorded (i.e packet sent, packet received, packet loss, jitter, latency) Is there anything else we ...
When a user is listening to their voicemails via their phones is there a RTP stream between the Unity Connection server and phone? if not, how is the message being replayed on the phone.THanks,
I know with the CM 4.1(3) this was not possible but with the new versions of CUCM 6 or 7 is it possible to have a call destined to both the Cisco IP Phone and over a SIP/QSIG Trunk?
In the device pool you can select the MRGL. So you will have to create three different MRGL, one for each site, and assign them to the respective device pool. http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a008020f198.s...
Gonzalo,I don't follow. here is the config for that loopback:interface Loopback0 description Interface for H323 Gateway Registration between AS and CCM4.1.3 ip address 10.11.120.57 255.255.255.255 h323-gateway voip interface h323-gateway voip bind sr...
If you are using RPs with a shared tree than I can see an advantage. For example all 10 sources in a same multicast group would send stream to an RP, then the RP would send a single stream to the recepient. So the link between the RP and recepient w...
