About saashfaq

saashfaq · 11-16-2005

Does Cisco 1721 supports inter-vlan routing? I have 4 different images taken from "Software Advisor" on CCO. Those images suggested by software advisor do show support of 802.1Q vlan/trunking on 1721, but when I load those images on 1721, I can creat...

saashfaq · 11-16-2005

By the way, one more comment, I'm trying to create intervlan routing using the fixed FE port on 1721. May be this particular port does not support that. it may require installing a separate FE module in it. But need to see comments if this is true.Th...

saashfaq · 11-16-2005

Thanks for prompt reply.I tried Enterprise base 12.3(14)T3, 12.3(14)T5, 12.4(5) IP Plus, all with same results. Under subinterface I can see the encapsulation command, but when I enter "encapsulation ?" the router says unrecognized command. If I hit ...

saashfaq · 11-13-2005

Good point. But remember that TCP is not a Network layer protocol, so it does look at the network layer. So when IP changes, it's only the matter of a second or two when network layer re-establishes. During the time network layer is down, TCP keeps r...

saashfaq · 11-10-2005

TCP is designed to take care of network link breaks. So when you disconnected from R1 by reconfiguring IP addresses, TCP connection did not break, instead it was re-transmitting to hear from remote end. Before the re-transmits timedout, you were able...

Member Since	‎11-10-2005 09:32 PM
Date Last Visited	‎03-07-2021 01:34 AM
Posts	5
Total Helpful Votes Received	4

User Statistics

User Activity

Inter Vlan Routing with 1721

Re: Inter Vlan Routing with 1721

Re: Inter Vlan Routing with 1721

Re: ask one TCP question

Re: ask one TCP question