Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Folks. I have an ASA5510 with multiple tunnels terminating into it. Some sites require a hairpin bend out into the internet after terminating, this works fine with an applicable NAT statement, however, is it possible to use a route-map to route...
Hello Folks. I've about 8 months on QoS, but am struggling to figure out how to allow fast browsing, but shape downloads via http. Does this have something to do with the tcp session time to a host? Traffic shaping seems applicable but not sure. Many...
Howdy. We?re changing from multiple leased lines to a Channelized T1, I?ve Google?d around and can?t find any config examples, only for ISDN. Does anyone have some configs or literature I can use?Sincerely
G Day. We're setting up a L2L VPN from a 837 to a ASA5510. The tunnel is working fine however i would like to have all traffic tunnel between the sites. We will have approximately 15 sites when done. I have tried to change the crypto ACL on the route...
Hello. Is it possible on an ASA5520 to utilize X2 WAN links to the internet, both T1 lines with different ISP?s; one for SMTP and one for VPN. Both interfaces are NAT?d and have connectivity. E0 is primary and has default route with a metric of 1 and...
Thank you for the reply. I wasn't very clear in my requirement, sorry it was a bit wishy washy. Ok we have a 20MB fiber link directly on to the internet and are a Tier II ISP - we rent a port from the local Telco and their fiber switch. We have ISA s...
Thanks. What info should the Telco give me so that when i configure this int i know what to assign to what site? Do you know if the 2CE1T1-PRI, is supported in the 2800 series?b
