Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
You need to ssh into the MLOM management. After you get in run scope chassis > scope adapter MLOM > scope ext-eth-if 0 > set admin-speed 4x10Gbps that will convert your 40Gb ports to 4 10Gb ports.
I am using the QSFP-H40G-CU1M. If i connect the VIC port from C220-01 to C220-02 then I still get no link. Only when I use a QSA do I get a link after setting the speed to 4x10Gb.
