Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
From the spoke/NHC side when configuring this command, is the nbma IP the same as the tunnel destination (hub)?ip nhrp nhs <tunnel ip> nbma <nbma-ip> multicast
Thank you, Paul.Yes, I had seen that "all in one" command that combines the two in the DMVPN documentation I have been looking over. I have some old DMVPN static configs across my enclave that I am trying to clean up by switching to the dynamic setti...
Are both of these commands required for the NHC spokes? Or will either of them work and perform the same function?ip nhrp map multicast nbma-IP ANDip nhrp nhs <tunnel ip of NHS>
I had the same problem with a trunked interface on a 3850 switch.I was able to add the following config to the interface which moved it out of VLAN 1 to VLAN XXX. "switchport access VLAN XXX"interface GigabitEthernet1/0/20switchport access VLAN XXXsw...
The government provides a list of countries that are TAA compliant. If your switch is marked as made in China, it is not TAA-compliant.https://www.gsa.gov/buy-through-us/purchasing-programs/multiple-award-schedule/help-with-mas-contracts-to-sell-to-g...
