Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am working with a client that has Meraki MXs at each of their 5 sites and each site has a S2S back to our datacenter. Every site seems to be functioning fine except for their main site. The tunnel went down earlier today and came back up but all su...
I have a client that decided to switch ISPs on their own. AT&T installed an MX67. They gave the customer a /29 block. They configured the MX67 in passthrough. The Meraki WAN is configured with .122 in the block and it's default gateway is set to .121...
Hello all,We have a client that has a MX84. They also have a Palo Alto that is managed by another vendor but sits inside the network and they have servers that sit behind the Palo Alto. Is it possible to configure a non Meraki VPN between the MX and ...
Hello all,
I have been working with a speed issue on an ASAv in a datacenter. I don't have access to the backend of the ASAv. We have a site to site VPN tunnel configured between the datacenter and the customer. We have been troubleshooting this for ...
No, just the one main site from the ASAv to the MX95 goes down. I was just stating they have 5 sites and only one goes down. Below is the message from the ASA.Feb 28 2025 07:47:22: %ASA-3-713123: Group = 50.x.x.x, IP = 50.x.x.x, IKE lost contact with...
Iperf tests inside the LAN achieved 8Gbps up and down. It seems the issue is once the packet leaves the LAN. The datacenter manager said it's shared bandwidth with other clients and the ASAv is behind a NAT. He said nothing is throttled.
Yes it's been tested. They did iperf tests after changing the MTU to 1300. They get 125Mbps down and no matter what size transfer they tried to upload it's 1Mbps upload.
