Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I cant get into the FMC anymore. I can get into the Cisco Firepower 2130 Threat Defense and elevate to expert mode if needed. Does anyone know how to change the password for the FMC through the OS only?
Hello,I have a firewall 1120 ASA series and I am not understanding how the initial device works. I first want to change the management IP. Is that going to be Managment1/1 interface? Assuming it is, I can ping that new ip i made. How do I ssh to the ...
Hello,I have a firewall 1120 ASA series and I am not understanding how the initial device works. I first want to change the management IP. Is that going to be Managment1/1 interface? Assuming it is, I can ping that new ip i made. How do I ssh to the ...
This might be a dumb question but how would you set up the ASA firewall 1000 without internet connection? I have a switch that connects to it. I think I can console into it with putty but isnt there a gui ?
Hello,I just built a new cisco call manger 15 and added two nodes. When I try to go to system (click node2)> cisco unified CM> apply config it says there are no associated devices to apply configuration. It will work fine for node 1 When I also go t...
So I went under Management 1/1 and did something like this:ip address 192.168.1.1 255.255.255.0
nameif management
security-level 100
no shutdownPer this documentation:CLI Book 1: Cisco Secure Firewall ASA Series General Operations CLI Configuration G...
When I console to the firepower i type enable but it keeps asking for a password that we have not set yet. any idea?I typed Admin123 but its not working
