Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,i don't arrive to connect at PIX515 with command telnet on interface Outside 192.168.0.4 from Cisco 831 '192.168.0.253'.Internet---C831----------PIX515------LAN 192.168.0.253 168.0.4 10.0.0.11 0.1When i am inside 'LAN 10.0.0.1' i have not ...
Hello,i would like limited trafic bandwitch for an FTP application for host 10.10.10.1 with QOS.i try this but when i donwload via FTP site my speed it's 80 KO/s.class-map match-all ftp match protocol ftp match access-group 1 match qos-group 1!!polic...
Hello,Is it possible to make a QOS appilcation(FTP or HTTP) ?i would like to reserve an pourcentage of my bandwitch for example FTP or HTTP application. I see with class-map.And if it's possible, what is a IOS correct, please ?Best regards,Fabrice.
Hello,I install MRTG for monitoring my routers (cisco837)and i have a problem with two routers because a snmp alert don't work.On another router Cisco837 i don't have this problem.When i launch command perl cfgmaker, i return error msg:SNMP error no ...
Hello,is it possible to connect with telnet session form outside ?because i have created a password and i have enabled the telnet from outside but it doesn't work ?only work from inside with my Putty client with telnet and ssh.On c831, i try to make ...
Hello,I found to connect in SSH from client pc to if_inside PIX.i don't found for Outside from C831, i tape this command line:ssh -c 3des -l pix -v 1 192.168.0.4but it doesn't work, can you help me please ?Regards,
Hello,Thank you for reply, but i don't make this.How do you configure this SSH on the Outside interface PIX ?How do you enable SSH (aaa) on the PIX515 ?And after is it possible from my C831 to access to PIX with SSH ?i tried but i don't message error...
Hi,When i configured CAR matching for limiting the bandwitch on Cisco806 or cisco1720, i haven't problem. the configuration with Rate-Limit and ACL for FTP is correct an works but if i enabled the crypto map, it doesn't work.I have problem only with ...
