Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are currently using Cisco Firepower 4140 (FTD v7.2.5) with Cisco FMC 4600 (v7.2.9).We would like to understand the maximum limit for manual entries (IPs and URLs) that can be added under Security Intelligence → URL Lists / Network Lists & Feeds.Sp...
We have two Cisco FMC-4600v7.2.9 (build 44) running in HA is two separate geographical sites. Both were in HA and running perfectly. HA failover also working perfectly. But now it's showing HA Sync Failed. Please find the screenshots shown below.Plea...
Issue Summary:Our FMC is running on version 7.2.9 (build 44). The Threat license is out of compliance, but we should still be able to update manual feeds. However, we are facing issues when updating Security Intelligence (SI) feeds manually.Observed ...
CSCwh73915 - Static IP Assignment not working using attribute msRADIUSFramedIPAddress when posture is enabled.Solution:We can assign static IP, if we use parameter radius ip address= msRADIUSFramedIPAddress in Posture unknown authorization profile....
We have a cisco ASR1009-X, here we have configured bridge-domain interface using 2x10Gbps interface. But the new virtual interface bdi1 is showing low bandwidth of 1Gbps only.Query:- Even if 10G link is bundled in bridge-domain interface, if the traf...
Findings:- Feed URL reachability and format were fine.- However, SI updates were not getting applied to FTD.- Upon investigation, it was observed that the root filesystem (/dev/root) on the FMC had reached 100% utilization.- Due to lack of disk space...
We should create new entries in the list feed.And we are using HTTP feed. Also getting 200 OK request. But it's not working.admin@DC-INTERNET-FW-01:/ngfw/Volume/home/admin$ curl -I http://10.196.220.131/Firewall/ipv4_blacklistall_11_aa.txtHTTP/1.1 20...
> show logging | grep SI <== Running this command in FTD generates logs of logs.Actually, there is an interface namely DC_INTERNET_INSIDEINT so, all logs generated is shown.Can you specify the exact string to find.
