Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,was just wondering how to configure IP addresses on the interfaces for my Cisco 5505 Firewall.When trying to use the command:"interface ethernet0/1""ip address 192.168.1.10 255.255.255.0"I get the message "This command can only be configured o...
Hi all,I apologise if I miss anything out or don't understand straight away, as I am new to networking.I have been given a Cisco 5505 Series Firewall to mess around with, and I have a few questions. (I am using PuTTY as the virtual terminal connectio...
Okay, that makes a lot of sense. I didn't realize that the IP interfaces were Layer 2 devices, my apologies. As I mentioned, I am relatively new to networking, so I didn't exactly understand how it worked. ]Thanks.
I've replicated the config used by Georg, but what are the commands used to configure the Ethernet interface on vlan1? (Unless DHCP is auto-enabled by default, in which case is okay).
Yes, it looks very similar to this setup. But how would I configure the IP addresses on, say, Ethernet 0/1 to "192.168.1.2 255.255.255.0"? As it states that "This command can only be configured on VLAN interfaces".Do I need to enter a dedicated comma...
Sorry, I'm quite new to all this. The config for the subnet is 255.255.255.0.As for the topology, I'm not really sure. Was just wondering if I could configure the DHCP and integration in the command line interface.
