Good morning,
Here is my situation and I can't figure it out. I just installed a Nexus 9332 dual core devices and I am UNABLE to see the information in the logs concerning a permit statement I have on the ACL. I put log at the end of the statemen...
I have just implemented a redundant network with redundant core and distribution nexus switches. When I ping from "Core-1" ping runs normal. However when I run a ping from any of the other 3 switches I get DUP ping replies. Is this normal in a r...
So I installed a 48 port cisco 9300 and all the sfps that we inserted into the slots were recognized. I had to reboot the switch and now ports 33-48 don't recognize any SFPs we place in the slots. Any suggestions?
I can’t post that due to it being on a classified network. I’m literally trying to build the ACL versus putting permit in any any and permit tcp any any at the bottom of the acl since it’s highly frowned upon in the government.Kevin
The problem is I’ve walked into a situation that they don’t know all the ports allowed. So I have petit ok any any and permit tcp any any in order to try and figure out what’s traversing the network and then build the ACL which is why I need to see w...
