Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have some 9300s that us an old IP and helper on vLAN1 - previously the network team created vLAN80 and assigned a management IP here too so they didn't need to clean up the old one, so we have 2 MGMT IPs.We want to remove the old IP from VLAN1 - r...
I have just got some brand new C9300s, I have them ready and have stacked their cables per the required for using 3 but the master switch still wont see the others, did I miss something ?I tried booting each switch in order too.M
Hi there,We are trying to get some endpoint redundancy in place and have the following switch's.Room 1 - Catalyst 9300 x4 <- Brand NewRoom 2 - Catalyst 2960-X x4 <- EOL 2027Is it possible to create 2x 4 Stacks and then setup active/active between the...
But these are 3 brand new C9300-48P-E V05 units that came with stacking cables and they are all on the same OS there is no reason why they're not compatible ?
