Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
is it ok to use two seperate subnets for NAT purpose? actually it is at one of our new clients.. this is something totally new i have seen....ip address outside 67.88.68.198 255.255.255.224ip address inside 192.168.0.1 255.255.255.0global (outside) 1...
one of the most imp things... have you checked with the ISP whether there is any static ARP entry for firewall on router...besides this i dont see anything wrong with the configuration.
Hi, before going to any kind of solution>>ip address inside 10.0.0.1 255.255.255.252are you really using such a small subnet or you have some router after this?OK.... 'route inside 192.168.0.0 255.255.0.0 10.0.0.2 1 ', this actually kinda answeres my...
Ok, I'll take a shot at this.. The error says your PIX couldn't connect to the CA server... Make sure you're not blocking TCP traffic between the PIX & the CA. If traffic isn't blocked, is the CA setup?...>ca identity cisco x.x.x.x:/certsrv/mscep/m...
