Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are migrating to a CISCO ASA firewall. We have multiple websites hosted on a single webserver. The webservers default gateway points to the old firewall and we don't want to change all websites at once. We've attempted setting up a test website. W...
I've been searching for any documentation on how autonegotiation works? In addition I've been trying to find the RFC that covers autonegotiation. Can anyone provide links?Thanks.
H'lo,Looking for any documentation on changing IP Schema.Setup is a bit unique. IP address are going to stay the same. Just need to change mask. Mask was created to small and has become unmanageable. All remotes offices have been changed and all that...
How do you remove a port from a VLAN.If a port has been assigned to a port using "set vlan vlan_ID mod/port". How do you remove the port and not the whole VLAN. "clear vlan vlan_ID" will remove the vlan. "clear vlan vlan _ID mod/port" get unrecognize...
I think I follow.Below is our setup. What we'd like to do is have range 192.168.20.0 - 192.168.22.0 exluded from NAT.Thanks.interface Vlan10 description UMC ip address 192.168.10.254 255.255.0.0 ip nat insideinterface Vlan199 description INET ip addr...
OK I checked the switch and a sh po shows the port assigned to one VLAN, but sh vlan shows multiple VLANs on the port.But I think you've solve this for me.I'm not used to CATOS, thanks for your help.
