Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone know if there are plans to use the USB ports on the ASA5500 Series as the failover interface medium?To my mind (apart from the IP bit) it would be similar to a cable-based ACTIVE/STANDBY failover scenario.I have extreme difficulty in burn...
I have two ASA 5520 appliances running 7.0(4). I use the Management0/0 interface as a connection to the Internet as it is only 100mbps.That leaves me four Gigabit interfaces to use with DMZ architecture.I tried to configure active/standby failover u...
I am currently planning an OS upgrade project for a series of Catalyst 6500 LAN switches from hybrid mode to native IOS.I have one minor concern.I will have to upgrade 16 Cat6500's to IOS. The core switches will follow later.Are there any things to ...
We are currently reviewing the network infrastructure here with a view to implement NAC-2.In tandem, we'd like to upgrade the core Sup's to 720 cards but I notice that 802.1X support is scheduled for a "future" release of IOS.We currently happily run...
Does anyone know when the Aironet access points will be able to use any nominated VLAN as the management VLAN instead of VLAN 1?Currently we have a successful dot1X (EAP-TLS) implementation running but I am a little concerned with having to use VLAN1...
Thanks Vibhor, although the answer was disappointing!..And I suppose there aren't any plans to incorporate VRRP either? The native IOS for Cat Switches now plays nicely with VRRP so can we have it with our ASA's please???
Hmm.. The document you point me to is Aironet 1300 whereas I use the 1200. Though I didn't make this completely clear to be fair.There is a caveat at the start of the 1200 Series docs that states the equipment must use VLAN1 for management and autho...
When you enable 'Transparent Proxy' on BBSM53 it proxies all traffic regardless of client settings. I presumed that this was a feature to get around the problem if you have Guests on site with pre-configured, hard-coded proxy settings that did not m...
