Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all:I had posted a bit earlier about some frame errors that I was seeing on my 7204 router. Whenever a machine tries to download a file from a remote site, I get a lot of the following errors:TCP Previous Segment LostTCP Dup AckTCP Retransmission...
Hi:I have a 7204 VXR router. FA0/0 is internal net, fa0/1 is wan backup to dsl, s1 to frame relay isp and s2 load balanced over 2 t1s to co-location servers. Whenever we have a lot of traffic to the co-lo site (either running an app or downloading ...
Thank you all for the information. I appreaciate all your help and input. To clafify my setup. We have a 7204 router in our main office here. We are connected by two T1 lines to a co-location site where our some of our servers are held. The ip a...
Hi Mikhail:Thanks for the response. Here is the current sho int on FA in question.HTBYB#sho int fa0/1FastEthernet0/1 is up, line protocol is up Hardware is i82543 (Livengood), address is 0009.44a2.a801 (bia 0009.44a2.a801) Internet address is 10.2...
Mikhail:Thanks for the response. I'll try a different switch port for the router and statically enter port speed duplex and see if it helps.As for the jabber frames. On the fluke, it starts off with the router reporting the most. As more traffic h...
Thanks for the reply. I did a bit of reading on the ip tcp adjust-mss command and had a couple of questions. It says that this is a problem with PPP over Ethernet. I don't think I'm running PPP on the interfaces that have the problem. They are de...
Hi:Thanks for the reply. FA0/0 is connected to a switch so I can set that to full duplex. We are running RIP to advertise our internal subnets and I believe we are using OSPF to advertise routes to our ISP for internet connectivity. I would guess ...