Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My ADSM is failing when trying to load the configuration from the device. The Failover works fine, but the primary locks at 17% everytime....any suggestions?
We have a Cisco 7920 that I can't seem to get configured to authenticate to our AP1242AG's. Everything seem to be set correctly on the 7920, but I don't even see an "authentication failed" message on the AP!! Am I missing something in configuring...
User A was moved to a over to a VLAN on our network yesterday, which contains (6) 2950 switches trunked together via the GigabitEthernet ports, routing through a 2801, through a firewall, to a 2600 router and out to the Internet now he's having probl...
GOT IT!!!!! The 7920 broadcast a default username for EAP-FAST authorization. (FAST-MAC ADDRESS), this has to match the username put on the physical phone in the Network Profiles-->Custom Profile-->802.11b Config-->EAP-->username. This name must a...
I ran a debug and this is what I got:Syslog logging: enabled (0 messages dropped, 2 messages rate-limited, 0 flushes, 0 overruns, xml disabled, filtering disabled) Console logging: level debugging, 3883 messages logged, xml disabled...
unfortantely that's not an option right now. I'm testing the phone for a remote client. At that remote site, they have a call manager and WCS, here at corporate we don't use wireless phones. But I should be able at the very least obtain an IP addr...
