About 8r-schumann

8r-schumann · 10-13-2003

I have remote sites with a VPN connection as a primary path and a frame-realy link for backup. The problem is that the Frame-Relay link is not seen as a FS to the VPN Tunnel. I have looked at the following URL:http://www.cisco.com/en/US/tech/tk365/...

8r-schumann · 06-26-2003

I have just installed CiscoWorks RME and was wondeirng how do i display the devices by their hostname instead of IP.

8r-schumann · 06-20-2003

I have Call Manager 3.3(2)spC and the Catalyst 4000 gatway blade running MGCP. If the switch/line card is relaoded the statement 'mgcp fax t38 inhibit' comes back and I have to manually set it to 'no' so my faxing works through the FXS ports on the ...

8r-schumann · 06-16-2003

I am looking for the maximum number of servers that a single Call Manager cluster running 3.3 will support.

8r-schumann · 03-11-2003

I just wanted to confirm a point i had once heard but can't seem to confirm. Can you have a mixture of PRI and CAS T1's on the same blade? I had heard once (I do not remember where) that the ports had to be all PRI or all CAS and i just wanted to c...

8r-schumann · 09-30-2004

You need to make sure that your time/date group is using the CCM that you think it is (something like local CM time).

8r-schumann · 09-24-2004

There is a very good tool for reading H.323 and ISDN messages from the traces:http://www.ciscopress.com/title/1587050757#Look at the downloads section. As far a reading the traces...I own the book and it will explain everything that you need to read...

8r-schumann · 08-31-2004

You should be fine with that setup.

8r-schumann · 08-11-2004

I have done this for sites and it is a little tricky. First you want to add a partiton and a new CSS for your gateways that contain translation patterns to prefix a 9 on ANI of the inbound calls.The tricky part is if you do not have 10 digit dialing...

8r-schumann · 08-06-2004

You have a free 4 port IVR (the IP Auto Attendant). Where you can do the above script.

Member Since	‎02-21-2003 05:04 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	96
Total Helpful Votes Received	9

User Statistics

User Activity

Setting preferred route in EIGRP ?!?!

Display devices by Hostname instead of IP?

Catalyst 4000 Gateway Fax Inhibit

Call Manager 3.3 Cluster Size

WS-X6608 Clarification

Re: Time sync between CCM & IP Phone

Re: CCM Trace Reader

Re: CCM 4.x - Nortel PBX Integration Setup

Re: How to add a 9 for missed calls

Re: Can PLAR or Hotline have option to dial out?