Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm having some trouble getting radius authentication going on a test AP. This is for a Meraki MR46.
Clients fail connection and there are no entries for them in the NPS server logs. I did a wireshark capture and realize there is NO traffic to/from...
I was about to plan an install for a customer and came across this gem. This customer has probably 950+ individual rules (which is a different issue to deal with) and this creates a hurdle. Has this been noted anywhere as a fix in future firmware rel...
Nothing odd. Same general template as the other locations. It finally saved but it took a while. I decided to just walk away from it and let it sit to see if anything would change. When I came back a few hours later the startup-config was updated. Lo...
Any resolution to this? I just RMAd a unit with this behavior and the replacement is doing the same thing. The running config always matches the dashboard but it never saves to the startup-config.
Everything is working and it looks like Andy had the right answer at the link below. Reboot the server. In our case it was restart Sophos security they had running on the server. There were no alerts or blocks indicated on the logs and the firewall w...
I thought of that after disconnecting and was going to check for other security apps that might be causing an issue. AP is local to the server. Windows firewall is disabled on server. I did not look for third party applications on the server to see i...
If they want to take a Catalyst and skin it, I wish they would at least offer CLI access via the dashboard like some of the other vendors. I could make the config changes needed that the dashboard side isn't capable of handling yet.
